Filter
Top Products
User's Manual
36
CHAPTER 4
ZONE 2
ZN2 SYSTEM ENABLE
BALANCE 2 LEFT
PWRUP SRC TAPE
PWRUP VOL MD PRESET
PWRUP VOL 45
MAX VOL 51
ZN2 OSD POPUP ON
Main Zone and Zone 2 Menu
Main Zone Menu
PowerUp Source
This sets the input source
which the TGP-5 will then
always select whenever the
TGP-5 is turned on.
Power Up Volume Mode
This lets you choose the vol-
ume level the TGP-5 reaches
when it is turned on. It ranges
from 0 minimum to 100 maxi-
mum. You can select from a
PRESET level, set below (the
power-up volume), or it can
play at the LAST level it was
playing before it was turned off.
The TGP-5 will always turn on
at the level set here, but it can
MAIN MENU
TRIMS
MODES
TONE
INPUTS
SETTINGS
SETTINGS
MAIN ZONE
ZONE 2
SPEAKERS
VIDEO
SOFTWARE
CONTROL
MAIN ZONE
PWRUP SOURCE DVD
PWRUP VOL MD PRESET
PWRUP VOL 45
MAX VOL 70
AUTO ON ON/OFF
be adjusted to any level after-
wards.
Power Up Volume
This allows you to set the PRE-
SET volume level mentioned
above. You might want to set it
to a low level to avoid any sur-
prises upon turn-on, especially
if other users like loud music.
Max Volume
The volume can be set to not
exceed a certain level. This
is useful if you have sensitive
speakers, sensitive neighbors,
or you would rather not have
others play your system too
loud.
Auto ON
When this is ON, the TGP-5 will
au to mat i cal ly switch to the next
input which starts to play. For
ex am ple, if you turn on your CD
player and press Play, the TGP-
5 will switch to CD. When you
turn on your VCR and press
Play, it will select the VCR
input.
You must set FULL AUTO to
ON in the INPUT menu, for
each input you want to use
with this fully automatic feature.
(See page 34, at the bottom of
the last column.)
If the TGP-5 is turned off while
the Auto mode is engaged, it
will turn on and select an input
when ev er an input be comes
active. For example, if you turn
on your CD player and press
Play, the TGP-5 will turn on and
select the CD input.
We recommend that you turn
off this feature if you are se-
lect ing the inputs manually, or
re cord ing.
Zone 2 Menu
These settings are like those de-
scribed for the Main Zone. In addition,
the entire Zone 2 can be enabled
or disabled, and the stereo balance
adjusted with this menu.
Zone 2 is set "disabled" from
the factory, so you should
use this menu to enable
Zone 2 when you are ready to use it.
The Power Up Volume has three
options: PRESET, LAST and FIXED.
The FIXED option allows you to set
the Zone 2 to a fi xed volume, not
adjustable with the remote. PRESET
and LAST are as described for the
Main Zone.
OSD popup can be turned on or off
with this menu.