Filter
Top Products
Connecting up02
16
En
Network connection
This player can be connected to a local area network (LAN) via the
Ethernet port on the rear panel.
After making the physical connection the player needs to be set up
for network communication. This is done from the Initial Setup
menu—see Setting up for network use on page 21 for detailed
instructions.
For best performance, we recommend using a 100BASE-TX
compatible PC and Ethernet hub.
Connecting via an Ethernet hub
If you already operate one or more PCs on a local area network, you
can integrate this player by connecting it to the Ethernet hub using
a standard (also known as “straight through”) type CAT-5 LAN
(Ethernet) cable (not supplied).
In the example configuration below, this player would be able to
access content from either of the PCs.
Connecting directly to a PC
If you only need to use one PC to act as a media server, you can
connect this player directly to the PC using a crossed (also known
as a “cross-over”) type CAT-5 LAN (Ethernet) cable (not supplied).
Controlling this player via another
Pioneer component
The CONTROL IN jack allows you to control this player via the
remote control sensor of another Pioneer component—typically an
AV receiver—that has a CONTROL OUT jack. Remote control
signals are passed through to the player from the remote sensor of
the other component, allowing you greater freedom in the
placement of your player.
• Use a miniplug cord (not supplied) to connect the CONTROL
IN jack of this player with the CONTROL OUT jack of your other
Pioneer component.
Using an external IR receiver with this
player
If you prefer to keep your AV equipment in a closed cabinet, you can
use an external IR receiver (such as a Niles or Xantech unit)
connected to the IR IN jack. You can thus have just the receiver
outside of the cabinet and still be able to control the player.
Tip
• You may need to set the IR RECEIVER switch (located under the
IR IN jack) for this player to recognize the IR receiver correctly.
• This player does not supply power to the external IR receiver.
Please see the operating instructions of the IR receiver for the
power requirements.