Filter
Top Products
9-49
DFP-3000
Fig. 8. Example of Screen After Completing Checks and Adjustments
13. After adjusting the level of one surround channel, return to step 9, and adjust the level of the other
surround channel.
14. After adjusting the level of the surround channel, save the changed data on a disk. Refer to steps 6,7,8
and stop the operations of the oscillator. (Operations can be stopped once here. In this case, end the
setup software.)
15. Click “Master” at “Channel Mute Status” of the setup software to mute the master volume, and then
turn on the power of the power amplifier.
16. Click “Master” of the “Channel Mute Status” to unmute the master volume, and then adjust the B-
chain (surround adjustment: adjustment of frequency characteristics and level) according to the
Surround EX processor manual at the Surround EX processor side (and amplifier level adjustment
knob). If pink noise must be generated at the Cinema Processor side, generate pink noises from the
DFP-D3000 setup software.
17. Perform all adjustments of the B-chain other than the Surround output as done normally at the DFP-
D3000 side.
18. After completing all adjustments, click “Disconnect to DFP” from the Config menu on the setup
software, end communication with the DFP-D3000 to end the setup software.
Do not operate as
for the equalizer.