Filter
Top Products
9-3
DFP-3000
REMOTE LEVEL CONTROL (Remote Fader) (9-pin D-sub Female)
Pin Signal
1 Remote potentiometer ground (min gain end)
2 MAIN FADE (input)
3 No connection
4 No connection
5 No connection
6 Remote potentiometer wiper
7 Remote potentiometer DC drive (max gain end)
8 Remote Tally output for LED
9 GND (ground)
AUTOMATION (37-pin D-Sub Female)
Pins in bold type changed after v2.63 firmware.
Pin Function Signal
1 Chassis Ground GND
2 Projector 1 Motor Start Input: Low = MOTOR 1 RUNNING
3 Master Mute command Input pulse: Low = MUTE or UNMUTE
4 Preset 1 Select (and tally pulldown) Input pulse: Low = SELECT
5 Preset 2 Select (and tally pulldown) Input pulse: Low = SELECT
6 Preset 3 Select (and tally pulldown) Input pulse: Low = SELECT
7 Preset 4 Select (and tally pulldown) Input pulse: Low = SELECT
8 Preset 5 Select (and tally pulldown) Input pulse: Low = SELECT
9 Preset 6 Select (and tally pulldown) Input pulse: Low = SELECT
10 Preset 7 Select (and tally pulldown) Input pulse: Low = SELECT
11 Preset 8 Select (and tally pulldown) Input pulse: Low = SELECT
12 Motor 1 Output tally: Low = MOTOR 1 RUNNING
13 Motor 2 Output tally: Low = MOTOR 2 RUNNING
14, 15 Logic Common 0 V
16, 17 Tally Common 0 V
18 Optical Change Over Command Input: Low = PEC 2, High = PEC 1
19 Optical Change Over Tally Output tally: Low = PEC 2 selected
20 Projector 1 Tally Output tally: Low = SDDS Reader 1 selected
21 Projector 2 Tally Output tally: Low = SDDS Reader 2 selected
22 Master Mute Tally Output tally: Low = Master muted
23 Pink Noise Input: Low = ON
24-29 Reserved No Connections
30 +5 V Power
31 +5 V Power
32 SDDS Data OK (any preset active) Output pulse: Low = SDDS OK
33 Projector 2 Motor Start Input: Low = MOTOR 2 RUNNING
34 AUX1 Digital Data OK Input: Low = Data OK
35 AUX2 Digital Data OK Input: Low = Data OK
36 SDDS Data not OK Output pulse: Low = SDDS NG
37 Reserved No Connection