Filter
Top Products
9-22
DFP-3000
6. Using as the changeover system
When using the system combining the DFP-D3000 and CP-500 in the changeover format, it is necessary
to supply the motor start pulse and change over command signals for the CP-500 as well. Therefore, add
the following signals to the control signal line and connect the cables.
Projector DFP-D3000 Automation I/O Connector CP-500 Motor Start Connector
(D-sub Connector, 37pin, Female) (D-sub Connector, 9pin, Female)
Signal Pin No. Function Pin No. Function
Projector 1 Motor Start Pin 12 Motor 1 Pin 1 Motor Start Projector 1
Projector 2 Motor Start Pin 13 Motor 2 Pin 9 Motor Start Projector 2
Picture Gate Select Pin 19 C/O command, tally Pin 3 Change Over Relay
Common Pin 16 Tally Common Pin 5 GND