Filter
Top Products
9-8
DFP-3000
3. Setting the output preset corresponding to SDDS
The following shows an example of the settings of the Preset Configuration screen of the setup software.
With SDDS, set the Fallback setting to AUX1. (Details are as shown at (1) of the following setting
example.) Like the DFP-D2000, for the inputs corresponding to SDDS, EQ must be turned ON and B-
chain and Surround Delay must be set.) (Details are as shown at (2) of the following setting example.)
4. Precautions for operations of the above system
. Do not turn off the power of the DFP-D3000 while running the film (including film which does not
record SDDS). No sounds will be output including the existing system if turned OFF.
. Adjust the volumes of AUX and SDDS using the Output Offset setting of the Preset Configuration
screen to eliminate the difference when AUX and SDDS signals are switched.
. If requiring the same operations as the DFP-D2000, set the preset switches (eight large switches on the
front panel) of the DFP-D3000 to preset (Preset 8 at shipment) corresponding to SDDS.
. If the AUX input Fallback setting is not set for some DFP-D3000 setup software versions, in some
cases, the Preset Configuration screen cannot be exited. In such cases, set Fallback without using the
setup software. Set Fallback by selecting the preset number.