Filter
Top Products
19
GB
C:\Documents and
Settings\pc13\Desktop\JC060000_2886257121SDE700_GB\2886257121\GB04REC_ST-
SDE700-CEL.fm
masterpage: Right
ST-SDE700
2-886-257-12 (1)
Receiving FM/AM Broadcasts
Using the controls on the tuner
1 Press BAND repeatedly to select the FM or
AM band.
2 Press TUNING MODE repeatedly to select
“AUTO T.”.
3 Turn TUNING/SELECT.
In case of poor FM stereo
reception
If the FM stereo reception is poor and
“STEREO” flashes on the display, select
monaural audio so that the sound will be less
distorted.
Press FM MODE repeatedly to select FM
MONO. The “FM MONO” appears and
“MONO” indicator lights up on the display.
To return to stereo mode, press FM MODE.
The “FM AUTO” appears and “MONO”
indicator do not lights up on the display.
Be sure to use the buttons on the tuner for this
operation.
1 Press BAND repeatedly to
select the FM or AM band.
You can also use FM or AM on the
remote.
2 Press DIRECT.
3 Press the numeric buttons to
enter the frequency.
You can also use the numeric buttons on
the remote.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
4 Press ENTER.
You can also use ENTER on the remote.
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you still
cannot tune in a station, the frequency is not
used in your area.
Direct tuning
1234567890
DIMMER DISPLAY
NAME IN FM MODE
TUNING MODE
MEMORY
RETURN
ENTERBAND
DIRECT
PRESET
DAB
INIT SCAN
AUTO-BETICAL
SELECT
POWER
TUNING/SELECT
1234
GB01COV_ST-SDE700-CEL.book Page 19 Tuesday, July 25, 2006 4:52 PM