Filter
Top Products
83
GB
Advanced Operations
x SW L.P.F.
Lets you set the low pass filter of the
subwoofer when multi channel Linear PCM
signals are input via an HDMI connection. Set
the “SW L.P.F.” if your connected
subwoofer’s crossover frequency do not have
low pass filter.
• L.P.F. ON
The low pass filter of the subwoofer’s cut off
frequency is set to 120 Hz.
• L.P.F. OFF
The low pass filter of the subwoofer is
turned off.
Note
This parameter is only available when HDMI input
signals are detected.
x ARC
Lets you enjoy the TV sound from the
speakers connected to the receiver via an
HDMI cable. For details, see “Enjoying the
TV sound via an HDMI cable (Audio Return
Channel)” (page 59).
• ARC ON
Audio signal is input to the HDMI TV OUT
jack.
• ARC OFF
Audio signal is input to the TV OPTICAL
IN jack or TV AUDIO IN jack.
Note
This parameter is not available when
“CTRL.HDMI” is set to “CTRL OFF”.
You can customize the settings of the receiver.
x DIMMER
Lets you adjust the brightness of the display in
3 levels.
x SLEEP
Lets you set the Sleep Timer on the receiver to
turn off automatically at the specific time. For
details, see “Using the Sleep Timer” (page 44).
x AUTO.STBY
Lets you set the receiver switch to standby
mode automatically after 30 minutes when
you do not operate the receiver or when there
is no signals input to the receiver.
• STBY ON
Switches to standby mode after
approximately 30 minutes.
• STBY OFF
Does not switch to standby mode.
Notes
• This function does not work in the following cases.
– TUNER input is selected.
– S-AIR receiver or surround amplifier is linked.
•If you use the auto standby mode and the Sleep
Timer at the same time, the Sleep Timer has
priority.
x NAME IN
Lets you set the name of inputs. For details,
see “Naming inputs” (page 43).
For details on S-AIR, see “S-AIR Operations”
(page 60).
SYSTEM menu
S-AIR menu