Filter
Top Products
7
To
Stop playing
Pause
Fast-forward
Rewind
Find the
succeeding
track (AMS**)
Find the
preceding track
(AMS**)
Remove the
cassette
Adjust the
volume
Press
π (or p*).
∏ (or P*).
Press again to resume playing.
π, then ) (or )*) for the
top side.
π, then 0 (or 0*) for the
bottom side.
π, then 0 (or 0*) for the
top side.
π, then ) (or )*) for the
bottom side.
) (or )*) for the top side.
0 (or 0*) for the bottom
side.
0 (or 0*) for the top side.
) (or )*) for the bottom
side.
§ on the tape deck.
Turn VOLUME on the
CMT-SD1/SD3 (or VOL /
*).
* Use the remote supplied with the CMT-SD1/SD3.
**The Automatic Music Sensor (AMS) feature
detects a blank space of more than four seconds
between tracks to locate tracks quickly.
Tips
•When you press 1/u on the tape deck while the
CMT-SD1/SD3 is power on, only the tape deck
turns on/off. Press 1/u on the CMT-SD1/SD3 to
turn on the CMT-SD1/SD3 component system.
•The TAPE indicator lights up in red when a
cassette is inserted and goes off when no cassette
is inserted.
•You can switch from another source to the tape
deck just by pressing · or ª (Automatic
Source Selection).
•To start playing automatically from the beginning
of the tape after fast winding (Auto Play), press
· while holding down 0 (for the top side) or
press ª while holding down ) (for the bottom
side).
•When listening to tapes recorded in Dolby NR, set
DOLBY NR to “B” or “C”.
•Using the timer function on the CMT-SD1/SD3,
you can wake up to music at a preset time. For
details, refer to “Wake up to music” in the
CMT-SD1/SD3 component system Operating
Instructions. When you set the Wake-up timer,
DOLBY NR must be set on the tape deck.
Note
The AMS feature may not work in the following
cases:
— the blank space between tracks is four seconds
or less.
— the sound source recorded on the right
channel is different from that on the left
channel as with a KARAOKE tape.
— low volume or low sound continues for a long
time.
— the TV is too close to the tape deck.
Other operations