Filter
Top Products
5
ç
ç
1 Firmly connect the system cable to
the SYSTEM CONTROL jack on the
CMT-SD1/SD3.
When using the MDS-SD1, connect to
the SYSTEM CONTROL jack on the
MDS-SD1.
3 For CMT-SD3, reconnect the Mains
lead of the super woofer to the
unswitched AC OUTLET on the
TC-SD1.
4 Connect the Mains lead of the
TC- SD1 to the AC OUTLET on the
CMT-SD1/SD3.
When using the MDS-SD1, connect to
the AC OUTLET on the MDS-SD1.
5 Connect the Mains lead of the
CMT-SD1/SD3 to a mains after you
complete all the connections.
If there is no sound or the tape
does not record at the first
operation
Make sure the plugs are inserted into the
jacks firmly.
•
If the plugs are not inserted into the C jacks
firmly, you may not be able to record the sound
of the CD, MD and TUNER onto a tape.
• If the plugs are not inserted into the
D
jacks firmly, you may not be able to listen
to the sound of the tape deck.
The plugs of the audio connecting cords may
be tight. Insert the plugs at the point shown
in “How to insert the plugs” in step 2.
Note
The system cable is used for exchanging signals
between the tape deck and the CMT-SD1/SD3 (or
MDS-SD1). If you do not connect the cord firmly,
the tape deck may not operate correctly.
2 Connect C to C, and
D
to
D
using the audio connecting cords.
Insert the plugs into jacks of the
same colour.
: signal flow
Not firmly inserted.
Insert to here.
CThe sound signals of the CD, MD
and TUNER flow through the
CMT-SD1/SD3 (and MDS-SD1) to the
tape deck when you record onto a
tape.
D
The sound signal of the tape deck
flows to the CMT-SD1/SD3 when you
play a tape.
How to insert the plugs
Insert the plugs firmly into the jacks.
SYSTEM
CONTROL
SYSTEM
CONTROL
TC-SD1
CMT-SD1/SD3
C
D
D