Filter
Top Products
6
Playing a tape
You can use any type of tape, TYPE I
(normal), TYPE II (CrO2) or TYPE IV (metal),
since the tape deck automatically detects the
tape type (ATS
1)
).
1)
ATS: Automatic Tape Selection.
With the side you want
to play facing up
FUNCTION
0/)
2)
This tape deck is able to switch between Dolby B-
type and C-type noise reduction systems.
1 Press 1/u on the CMT-SD1/SD3 to
turn on the CMT-SD1/SD3
component system.
The tape deck turns on automatically.
2 Press § on the tape deck to open the
cassette tray and insert a recorded
tape.
Press § again to close the cassette tray.
3 Set DIRECTION to A to play one
side, Å to play both sides once,
and a
3)
to play both sides
continuously.
4 Press ·.
Press ª to play the bottom side.
The function switches to “TAPE”
automatically, then the tape starts
playing.
3)
The tape deck stops automatically after repeating
the sequence five times.
To play a tape using the
CMT-SD1/SD3 component system
Do the following operations in step 4;
1 Press FUNCTION until “TAPE” appears in
the display.
2 Press TAPE( on the remote.
To play the bottom side, press TAPE(
again on the remote.
TAPE(
Tape deck
TC-SD1
The remote supplied
with the CMT-SD1/SD3
·
ª
•
•
•
•
•
•
•
•
•
0
10
)
0
∏
2
π
TAPE
indicator
ª
34
1/u
DOLBY NR
2)
VOL
0/)