Filter
Top Products
13
To cancel timer recording
Press TIMER SET.
To change the setting
Start again from step 1.
To check the setting / To use the
timer
Press TIMER SELECT repeatedly until “REC”
appears. The start time appears, followed by
the stop time, the preset number, and
“TAPE”, then the original display appears.
Press 1/u on the CMT-SD1/SD3 to turn off
the system. The tape deck stands by for the
timer recording.
To cancel the timer
Press TIMER SELECT repeatedly until
“TIMER OFF” appears.
Tips
•This tape deck is able to switch between Dolby B-
type and C-type noise reduction systems.
•The last settings are memorized. To activate
recording timer with the same settings, display
“REC” and turn off the power. It is not necessary
to set every time.
Notes
•You cannot activate wake up timer and recording
timer at the same time.
•Do not operate the system from the time the
power turns on until the playback starts (about 20
seconds).
•If the power is on about 20 seconds before the
preset time, the recording will not be made.
•The volume is reduced to minimum during
recording.
Precautions
About tempered glass
The front panel of this tape deck is made of
tempered glass, which has been known to break in
extreme circumstances.
On safety
•The unit is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet, even if the unit itself has been turned
off.
•Unplug the tape deck from the wall outlet (mains)
if it is not to be used for an extended period of
time. To disconnect the cord (mains lead), pull it
out by the plug. Never pull the cord itself.
•Should any solid object or liquid fall into the
component, unplug the tape deck and have it
checked by qualified personnel before operating it
any further.
•The AC power cord (mains lead) must be changed
only at a qualified service shop.
On placement
•Place the tape deck in a location with adequate
ventilation to prevent heat build-up in the tape
deck.
•Do not place the unit in an inclined position.
•Do not place the unit in locations where it is:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibration
— Subject to direct sunlight.
Before placing a cassette in the
tape deck
Take up any slack in the tape. Otherwise, the tape
may get entangled in the parts of the tape deck and
become damaged.
When using a tape longer than 90
minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
continued