Filter
Top Products
17
Additional Information
Recording Using a Timer
You can start recording on a tape at any time you want
by connecting a timer (not supplied). Please also refer
to the instructions of the timer for further help.
Advanced Recording Operations
TIMER
9/(
9/(
9(
PHONE LEVEL
A -AUTO CAL-B
POWER
0
(AMS)
p
)
(AMS)
PRr
- RMS +
CLEAR BACK FRONT
PAUSE
§
OPEN/
CLOSE
RESET
PITCH CONTROL
SYNCHRO DUBBING A B
START P
MEMORY
COUNTER BA
RESET MEMORY
REC LEVEL
REC MUTE REC
ON/OFF
MPX FILTER
TIMER
OFF
REC PLAY
DIR MODE
p
PRr
PAUSE REC MUTE REC
DUBBING LEVEL
BALANCE
PHONES
4
7
1
BLANK SKIP
A -DOLBY NR-B
5
8
2
AUTO PAUSE
RMS / START DISPLAY
RMS
CHECK SET
6
9
A+B REC
10
HIGH
>10
NORMAL
+–
– +
3
§
OPEN/
CLOSE
START (DECK B P)
5
46
37
28
19
100
MAXMIN R
L
0
(AMS)
)
(AMS)
9(
1 Insert (a) cassette(s) into either deck (or both decks).
Make sure that the connections are correct (see page
7).
2 Turn on the amplifier and play the program source
you want to record.
3 Prepare the tape deck for recording.
For single-deck recording
Follow Steps 4 to 6 on page 4, and press ( or 9 to
select the side of the tape.
For recording on both decks
•For Relay Recording, follow Steps 2 to 4, and 6 on page
14.
•For Simultaneous Recording, follow Steps 2 to 4, 6, and 7
on page 15.
4 On the tape deck, set TIMER to REC.
Before you set the timer in Step 5 below;
— select the Dolby NR system (see page 5)
— turn on the multiplex filter (see page 5)
— do automatic calibration (see page 12)
5 Set the timer to the time you want.
The tape deck turns off. When the set time comes,
the tape deck turns on and starts recording.
6 After you have used the timer, set TIMER on the
tape deck to OFF.
Notes
• Do not leave the TIMER switch at REC, or the tape deck will
automatically start recording the next time you turn on the
tape deck.
• During timer recording, recording starts from the side of the
tape being used when the power turns off.
In Relay Recording, however, recording on deck B always
starts from the front side of the tape.
• Do not insert cassettes into both decks when you do single-
deck recording. If cassettes are inserted into both decks and
“A” or “a” appears in the display, Simultaneous
Recording will start and the same material will be recorded
on both tapes.