Filter
Top Products
11
Advanced Playback Operations
Playing a Tape Using a Timer
You can start playing a tape at any time you want by
connecting a timer (not supplied). Please refer to the
instructions of the timer for further help.
Adding tracks to the end of a program
Press p (CLEAR) once, and follow Steps 2 to 4 in
“Creating Your Own Program (RMS Play)” on page 10.
To create another program
Press p (CLEAR) until the order on the program returns
to 0 and the cursor flashes above track number 1 in the
display, then follow Steps 2 to 4.
You can use your Sony stereo receiver’s remote to
perform RMS programming
If your Sony stereo receiver’s remote has RMS buttons, do
the following steps.
1 Turn on the receiver and press TAPE.
2 Press RMS/START.
3 Press ( or 9 to select the front or reverse side of the
tape, and the number keys (and the >10 key) to specify
the tracks.
4 Press RMS/START again to start RMS Play.
Note
For more information on the availability of Sony stereo
receiver remotes with RMS capability, contact your
nearest Sony dealer.
TIMER DIR MODE
9/(
9/(
9(
PHONE LEVEL
A -AUTO CAL-B
POWER
0
(AMS)
p
)
(AMS)
PRr
- RMS +
CLEAR BACK FRONT
PAUSE
§
OPEN/
CLOSE
RESET
PITCH CONTROL
SYNCHRO DUBBING A B
START P
MEMORY
COUNTER BA
RESET MEMORY
REC LEVEL
REC MUTE REC
ON/OFF
MPX FILTER
TIMER
OFF
REC PLAY
DIR MODE
p
PRr
PAUSE REC MUTE REC
DUBBING LEVEL
BALANCE
PHONES
4
7
1
BLANK SKIP
A -DOLBY NR-B
5
8
2
AUTO PAUSE
RMS / START DISPLAY
RMS
CHECK SET
6
9
A+B REC
10
HIGH
>10
NORMAL
+–
– +
3
§
OPEN/
CLOSE
START (DECK B P)
5
46
37
28
19
100
MAXMIN R
L
0
(AMS)
)
(AMS)
9(
1 Insert (a) cassette(s) into either deck (or both decks).
Make sure that the connections are correct (see page
7).
2 Prepare the tape deck for playback.
For single-deck playback
Press DIR MODE repeatedly to select A or a,
then press ( or 9 to select the side of the tape.
For playback of both decks in succession
Press DIR MODE repeatedly to select RELAY, then press
( or 9 on deck A to select the side of the tape.
(Playback on deck B always starts from the front side of
the tape.)
3 Set TIMER on the tape deck to PLAY.
Before you set the timer in Step 4 below;
— select the Dolby NR system (see page 6)
— adjust the pitch (see page 6)
— activate the Blank Skip function (see page 9)
4 Set the timer to the time you want.
The tape deck turns off. When the set time arrives,
the tape deck turns on and starts playing.
5 After you have finished using the timer, set TIMER
on the tape deck to OFF.
Note
If cassettes have been inserted into both decks for single-deck
playback, playback will take place only on deck A.