Filter
Top Products
20
GB
After recording
Press EJECT to remove the MD or press ?/
1 (power) to turn off the deck.
“TOC” starts flashing. The TOC is updated and
recording is completed.
Before pulling out the power cord
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the deck. Do not pull out the mains lead
before updating the TOC or while updating the
TOC (while “TOC” lights up or flashes) to
ensure a complete recording.
Protecting a recorded MD
• To protect a recorded MD, slide the tab on the
side of the MD to open the slot. In this
position, the MD cannot be recorded. To
record on the MD, slide the tab to close the
slot.
• If the MD is record protected, “C11” and
“Protected” appear alternately and the MD
cannot be recorded. Remove the MD, then
slide the record protection tab to the closed
position.
You can record a whole CD on an MD. You can
select the recording time by switching the
recording mode.
In addition to recording at normal speed, you
can also record at high speed (approximately 4×
normal speed).
When using the remote, switch the function to
MD.
1 Load a recordable MD.
2 Load a CD you want to record.
3 Press REC MODE repeatedly to select
the recording mode.
Select the desired recording time.
*Maximum recording time using a 60-minute
MD.
4 Press CD SYNCHRO NORMAL or HIGH.
To record using High-Speed CD-MD
Synchro Recording, press HIGH.
The MD deck stands by for recording and
the CD player pauses for play.
5 After “New Track” is displayed, press
H or X on the MD deck.
Recording starts.
When the recording is completed, the CD
player and the MD deck stop automatically.
Tab
Slide the tab
Recording a CD on an MD
— CD-MD Synchro Recording/High-
Speed CD-MD Synchro Recording
To record in Select Recording time*
Stereo Blank (No
indicator)
60 minutes
LP2 Stereo LP2 120 minutes
LP4 Stereo LP4 240 minutes
Monaural MONO 120 minutes
2
3
x X
1
4
5
GROUP
ON/OFF SKIP