Filter
Top Products
83
While recording
The USB cradle and
the recorder become
hot during the
charging procedure.
• This is normal and poses no danger.
Symptom Cause/Remedy
The recorder
overwrites existing
materials when record.
• The record starting-position setting (“REC-Posi”) is set to
“From Here”.
, Set “REC-Posi” setting to “From End”.
The recording starts
from the end of the
disc even when “REC-
Posi” is set to “From
Here”.
• The group recording (“ : REC”) is set to “ : REC ON”.
(You cannot overwrite tracks when “ : REC” is set to “ :
REC ON”.)
, Set the group recording setting to “ : REC OFF”
(page 63).
“REC-Posi” (the
record-starting point)
cannot be set to “From
Here”.
• The group recording (“ : REC”) is set to “ : REC ON”.
, Set the group recording setting to “ : REC OFF”
(page 63), and then set “REC-Posi” to “From Here”.
Recording cannot be
done correctly.
• Audio sources may not be securely connected.
, Disconnect the audio sources once and connect them again
(pages 23, 29, 31).
• There is no digital signal from the portable CD player.
, When recording digitally from a portable CD player, use
the AC power adaptor and disable the anti-skip function
(such as ESP) on the CD player (page 25).
• The analog recording was made using a connecting cord with
an attenuator.
, Use a connecting cord without an attenuator.
• Recording level is too small to record (when adjusting the
recording level manually).
, Pause the recorder and adjust the recording level (page 34).
• The power sources was disconnected or a power outage
occurred during recording.
, The recording result is not recorded on the disc. Make
recording again.
• The premastered MD is inserted.
, Replace to the recordable MD.
• The remaining recordable time on the disc is 12 seconds or less
(“DISC FULL” appears).
, Replace the disc.
Symptom Cause/Solution