Filter
Top Products
24
If the recording does not start
• Make sure the recorder is not locked (pages
15, 20).
• Make sure the MD is not record-protected
(pages 22, 79).
• Premastered MDs cannot be recorded over.
To know the recording
condition
The REC LED lights up or flashes
according to the recording condition.
To Press
Record from the end of the
current contents
1)
1)
If “REC-Posi” is set to “From End”, recording operations will always start from the end of the
previously recorded material without pressing the END SEARCH button (page 63).
Press END SEARCH, and then press and slide zREC.
1)
Record over previous
material from a point
partway through
1)
Press N, or press the 5-way control key towards ., or
> to find the start point of recording, and then press x to
stop. Then press and slide zREC.
Pause Press X
2)
.
Press X again to resume recording.
2)
A track mark is added at the point where you press X again to resume recording while pausing; thus
the remainder of the track will be counted as a new track.
Remove the MD Press x and open the lid.
3)
(The lid does not open while
“TOC Edit” flashing in the display.)
3)
If you open the lid while “REC-Posi” is set to “From Here”, recording will begin from the top of the
disc the next time you record. Check the point to start recording on the display.
Recording
condition
REC LED
While recording lights up
flashes according
to the loudness of
the source while
recording with a
microphone
(voice mirror)
Recording standby flashes
Less than 3
minutes’ recording
time available
flashes slowly
A track mark has
been added
1)
1)
Except when track marking was done
manually or automatically using Auto Time
Stamp (page 33).
goes off
momentarily
While checking-out flashes faster