Filter
Top Products
13
MZ-B100
[Configuration of Test Mode]
[Manual Mode]
Mode to adjust or check the operation of the set by function.
Normally, the adjustment in this mode is not executed.
• Transition method in Manual Mode
1. Setting the test mode. (See page 12)
2. Press the
> or [EASY SEARCH +] key activates the manual
mode where the LCD display as shown below.
3. The optical pick-up moves outward or inward while
the > or . key is pressed for several seconds respec-
tively.
4. Each test item is assigned with a 3-digit mode number;
100th place is a major item, 10th place is a medium item, and
unit place is a minor item.
[Manual Mode]
[Servo Mode]
[Audio Mode]
[Power Mode]
[OP Alignment Mode]
[Overall Adjustment Mode]
[Self-Diagnosis Display Mode]
Press the > or [EASY SEARCH +] key
[Key Check Mode]
[Test Mode $Display Check Mode%]
Press the x key
Press the x key
Press the x key
Press the x key
Press the . or [EASY SEARCH --] key
Press the N or [REC] key on the set
Press the [DISPLAY] key
Press the [TRACK MARK] key
on the remote commander for several seconds.
Quit the key check or open the upper panel
[Sound Skip Check Result Display Mode]
LCD display
Manual
[EASY SEARCH +] key:100th place of
mode number
increase.
[EASY SEARCH --] key: 100th place of
mode number
decrease.
[Major item switching]
[EASY SEARCH +]
key: 10th place of
mode number
increase.
[EASY SEARCH --] key: 10th place of
mode number
decrease.
[EASY SEARCH +] key: Increases the
adjusted value
[EASY SEARCH --] key: Decreases the
adjusted value
[Medium item switching]
N
key
x
key
[Minor item switching]
[Adjusted value variation]
X
key: When adjusted value is
changed:
Adjusted value is written.
When adjusted value is
not changed:
That item is adjusted
automatically.
[Adjusted value write]
N
key
N
key: Unit place of mode number
increase.
x
key