Filter
Top Products
56
US
One of the following messages may
appear or flash in the display during
operation.
Disc/ Tape/ Timer
No Disc
There is no disc on the disc tray.
No Tab
You cannot record onto the tape because
the tab has been removed from the tape.
No Tape
There is no tape in the tape deck.
Not in Use
You have pressed a button those operation
is not allowed or invalid at that time.
OFF TIME NG!
The on time and off time of Play Timer or
Recording Timer is the same.
PUSH SELECT!
You tried to set the clock or timer during
timer operation.
Push STOP!
You have pressed PLAY MODE on the
remote during playback.
Reading
The system is reading information of the
disc. Some buttons are not available.
NO STEP
You have cleared all the steps you
programmed.
OVER
You have reached the end of the disc
while pressing M during playback or
pause.
Step Full!
You tried to program more than 25 steps.
SET CLOCK!
You pressed CLOCK/TIMER SELECT
on the remote before the clock is set.
SET TIMER!
You pressed CLOCK/TIMER SELECT
on the remote before Play Timer or
Recording Timer is set.
USB device
Reading/USB Reading
The system is reading information of the
USB device. Some buttons are not
available.
Data Error
You tried to play back an MP3 audio track
that is not playable (page 51).
Device Error
The USB device could not be recognized
or an unknown device is connected.
Fatal Error!
The USB device was removed during
recording or erasing operation, and may
have been damaged.
NO STEP
All of the programmed tracks have been
erased.
Not Supported
An unsupported USB device is connected
or the USB device is connected through
an USB
hub.
No Track
No playable MP3 audio track is loaded in
the system.
Not in Use
You tried to perform a specific operation
under conditions where that operation is
prohibited.
Over Current
An over current was detected.
Messages