Filter
Top Products
45
US
Other Operations
— Power Saving Mode
The demonstration display and the clock
display can be turned off to minimize the
amount of power consumed during
standby mode (Power Saving Mode).
Press DISPLAY repeatedly while
the system is turned off.
Demonstration
1)
t No display
(Power Saving Mode) t Clock
2)
t
Demonstration t …
1)
The display changes and the indicators flash
even when the system is turned off.
2)
The clock display automatically turns to
Power Saving Mode after 8 seconds.
Note
You cannot perform the following operations
during Power Saving Mode:
– Setting the clock (page 18).
– Changing the AM tuning interval (page 32).
– Turning on the system by pressing the
function buttons (CD, TUNER/BAND,
TAPE A/B, AUDIO, VIDEO or ).
– Changing the CD/USB power manage
setting (page 32).
— BUILT-IN BEAM
1 Press BEAM MODE repeatedly
to select the FRONT BEAM and
BOTTOM BEAM.
FRONT BEAM is located at the front
side of the unit and reacts according to
the high frequency (treble) of the
music.
BOTTOM BEAM is located at the
bottom side of the unit and reacts
according to the low frequency (bass)
of the music.
2 Turn OPERATION DIAL to select
the setting you want.
3 Press ENTER.
To adjust the brightness of the beam
Refer to “BEAM DIMMER” setting in
“Changing the display” (page 44).
Tip
You can change the lighting effect of the beam
by pressing FRONT and BOTTOM BUILT-IN
BEAM on the X-TRANCE PRO remote
repeatedly.
Turning off the display
USB
Changing the lighting effect of
the beam
Setting Effect
F.BEAM ON,
B.BEAM ON
The front and bottom
beam lights up.
F.BEAM 1,
B.BEAM 1
The front and bottom
beam flashes according
to the audio source.
F.BEAM 2,
B.BEAM 2
The front and bottom
beam flashes according
to the audio source.
The flashing speed
depends on the audio
source.
F.BEAM OFF,
B.BEAM OFF
The front and bottom
beam lights off.