Filter
Top Products
Chapter 3 Using the Unit as a Player in an Editing System
38
GB
Chapter 3 Using the Unit as a Player in an Editing System
Video/audio signal connections
The following shows an example of video/audio signal connections in an
A/B roll editing system. In this example, analog component signals are
used as the video signals and XLR 3-pin connectors are used as audio
input/output connectors.
DPS-D7 or other delay unit
1
1
2
3
3
3
3
3
3
33
VIDEO INPUTS
COMPONENT 2
VIDEO INPUTS
COMPONENT 1
COMPONENT VIDEO Y,
R–Y, B–Y OUT
COMPONENT VIDEO IN
(Y, R–Y, B–Y)
PGM OUT
COMPONENT 1
AUDIO IN
CH-1
CH-2
LINE OUT 2 LINE OUT 1
1234MIC/LINE
IN
AUDIO OUT CH-1 CH-2
COMPONENT 1
OUTPUT
AUDIO OUTPUT
CH-1
CH-2
CH-2 OUTCH-1 OUT
CH-2 INCH-1 IN
DSR-85/85P
(recorder)
UVW-1600/1600P
(player 2)
DFS-500/500P
DME Switcher
DSR-40/40P (player 1)
MXP-290
Audio Mixer
3 Cable with XLR connectors
(not supplied)
Connections for an A/B Roll Editing System
Settings on the DSR-85/85P (recorder)
For details of the video/audio input and audio mode
settings, refer to the instruction manuals for the devices
used.
Switch Setting
AUDIO IN 600 Ω ON/OFF ON
AUDIO IN –6 dBu/0 dBu/+4 dBu Normally +4 dBu
1 12-piny3×BNC cable (not
supplied) (Consult your Sony
dealer about this cable.)
2 12-pin dubbing cable (not
supplied)