Filter
Top Products
42
GB
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 41).
1 Press TUNER/BAND repeatedly to
select FM or AM.
2 Press . or > repeatedly to select
the desired preset station.
To select the desired preset number
using the numeric buttons on the
remote
Press numeric buttons instead of performing
step 2.
To enter preset number 10 or higher, press >10
and the corresponding numeric buttons. To
enter 0, press 10/0.
Example:
To enter preset number 20, press >10, then 2 and
10/0.
Listening to non-preset radio
station
— Manual Tuning
1 Press TUNER/BAND repeatedly to
select FM or AM.
2 Press m or M repeatedly to tune in
the desired station.
Tips
• To improve broadcast reception, reorient the
antennas.
• When an FM stereo programme has static noise,
press REPEAT/FM MODE on the remote
repeatedly until “MONO” appears. There will be no
stereo effect, but the reception will improve.
• Press and hold m or M in step 2 above. The
frequency indication changes and scanning stops
when the system tunes in a station (Automatic
Tuning).
Other Operations
To
Tune in a station
with a weak
signal
To set another
station to an
existing preset
number
To change the AM tuning interval
(Except for the European and Middle
Eastern models)
The AM tuning interval is factory-preset to 9 kHz (or
10 kHz for some areas). To change the AM tuning
interval, tune in any AM station first, then turn off the
system. While holding down M and ?/1, turn the
system back on. When you change the interval, all the
AM preset stations are erased. To reset the interval,
repeat the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• Pressing TUNER/BAND while the power is off
automatically turns the power on.
• The preset stations are retained for half a day even
if you unplug the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
Do this
Follow the procedure described in
“Setting presets through manual
tuning”.
Start over from step 1. After step
3, press . or > repeatedly to
select the preset number where you
want to store a new station, then
proceed to step 4.
Presetting radio stations (continued)