Filter
Top Products
15
GB
Getting Started
xRear speaker position and height
Specify the position and height of the rear
speakers. The default settings are underlined.
Position diagram
• R. PL. BEHIND
Select this if the rear speakers are located in
the section B.
• R. PL. SIDE
Select this if the rear speakers are located in
the section A
Height diagram
• R. HGT. LOW
Select this if the rear speakers are located in
the section D.
• R. HGT. HIGH
Select this if the rear speakers are located in
the section C.
Specifying the speaker
parameters
Use the remote for the operation.
1 From your listening position, press
AMP MENU.
Adjustable menus and parameters are
described below.
2 Press V or v repeatedly until “LEVEL
MENU” appears.
3 Press ENTER.
4 Press V or v repeatedly to select the
parameter.
5 Press B or b repeatedly to select the
setting you want.
6 Repeat steps 4 to 5 to set other
parameters.
7 Press ENTER.
Tips
• You can use the digipad instead of the cursor
buttons (V/v/B/b).
• You can use “SPEAKER SETUP” in the Setup
Display to specify the balance, level, and test tone
parameters (page 30).
Adjustable parameters
The default settings are in the parentheses.
xBALANCE
• FRNT L___R: (center)
Balance between the front left and right
speakers.
• REAR L___R: (center)
Balance between the rear left and right
speakers.
Range: 6 steps to the left and 6 steps to the right
(13 steps)
90
20
45
AA
BB
60
30
CC
DD
continued