Filter
Top Products
u
..
r=!
—
r
IT
-—
—.
—.
,
,———.
4
MANUAL
SELECT
2
1
<DOWN,
*UP
1
2
-a u
Press VIDEO/AUX and start playback of the video
source.
“VIDEO is displayed.
Press DOLBY PRO LOGIC.
“NORMAL” is selected, and the playback sound has the
DOLBY PRO LOGIC effect.
To cancel DOLBY PRO LOGIC mode
Press DOLBY PRO LOGIC repeatedly until “PRO-OFF is
displayed.
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the sound
levels of the center or each surround speaker can be adjusted
during playback of laser discs or video software.
1 Press MANUAL SELECT (TEST) on the remote control
repeatedly to select “CEN” (center speaker) or “SUR”
(surround speakers).
2 While the “CEN” or “SUR” is displayed, press ~ DOWN or
~ UP on the remote control to adjust the volume.
...... l~...’,’’!”,’! ,! ’,!,>..! :--
..
‘v,’ ‘)!,,,,’”!’ ! ., :-.-Y t.+ ‘!s7,. -,.:.!”,’ : --- @ “ : % .Sw .
g
ADDITIONAL DOLBY PRO LOGIC MODES
%
J
In addition to the NORMAL mode, this unit is also e~uipped with ~~-,,
the PHANTOM and the 3 STEREO modes,
.,,-,
W%T
PHANTOM mode: Use this mode when no center speaker is
$;~.
connected. The center channel signals are output through the !j&~
left and right speakers.
‘:J!p:
3 STEREO mode: Use this mode when no surround speakers
“~
are connected. This mode reproduces rear sounds through tha O
front speakers.
Q
To select PHANTOM or 3 STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY
PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode
is displayed cyclically as follows.
~ NORMAL ---+ PHANTOM+ 3 STEREO ~
~ PRO-OFF (cancel) ~
To adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 of “ADJUSTING SPEAKER LEVEL
BALANCE”.
● Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the DIOLB~
PRO LOGIC is on.
● The full DOLBY PRO LOGIC effect cannot be obtained when
using software without
lltl WBVSURROUND[mark.
● The DOLBY PRO LOGIC is automatically canceled when the
headphones are plugged in.
● Set the microphone volume to OFF while the DOLBY PRO
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound can
not be reproduced correctly.
ENGLISH18