Filter
Top Products
INSERTING BLANK SPACES
This section explains how to record from the tuner, CD player, or
external equipment.
—
,,___
_.-.
1
,11
1
Preparation
● Use Type I (normal) tapes only.
● Set the tape to the point where recording will start.
● Note that recording is done on only one side of the tape.
1
2
3
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
= EJECT
Press function (CD, TUNER or VIDEO/AUX) and
prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source, press VIDEO/AUX and
play.
Press ● REC/REC MUTE to start recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press
■ ,
To pause recording, press II. (Applicable when the source is
TUNER or VIDEO/AUX) To resume recording, press it again.
To start recording with the remote control
First press
●/0 REC/REC MUTE, and then press<> within 2
seconds.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD.)
1 Press ● REC/REC MUTE during recording or while in
recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press 11 to resume recording.
To insert a blank space of less than 4 seconds, press
●
REC/REC MUTE again while ~ is flashing.
To insert blank !Waces of more than 4 seconds, after the deck
enters recording pause mode, press
● REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is
added.
About cassette tapes
~To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Tab for side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
o120-minute or longer tapes are extremely thin and easily
deformed or damaged, They are not recommended.
~Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
)
—
To erase a recording
● Make sure the microphone is not connected to this unit.
● Set the microphone volume to OFF (see page 19).
1 Insert the tape to be erased into deck 2 and press TAPE DECK
1/2 to display ‘(TP 2.
2 Set the tape to the point where the erasure is to be started.
3 Press
● REC/REC MUTE to start the erasure.
13 ENGLISH