Filter
Top Products
CD DIGITAL OUT
(OPTIONAL)
VIDEO/AUX IN
MD
SURROUND
LINE OUT
SPEAKERS
Refer to the operating instructions of the connected equipment
for details.
● The connecting cords are not supplied. Obtain the necessary
connecting cords.
● Consult your local Aiwa dealer for optional equipment.
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, VCRs, TV, MD players etc.).
Connect the red plug to R jack, and the white plug to L jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
This jack is recommended to connect with an MD player.
Use a cable with RCA phono plugs.
Connect the red plug to the
MD R jack, and the white plug to the
MD L jack.
● When MD player is connected to these jacks, no sound will be
output from the LINE OUT jacks.
This unit can output analog sound signal through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
with LINE IN (analog input) jacks.
m
Do not connect an equipment to LINE OUT and VIDEO/AUX IN
simultaneously. Otherwise, noise is generated and malfunction
occurs
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (digital
amplifier, DAT deck, MD recorder, etc.).
Remove the dust cap @ from CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to CD DIGITAL OUT
(OPTICAL) jack.
SURROUND SPEAKERS JACKS
Connect optional surround speakers with the 8 ohms to 16 ohms
impedance to the jacks.
POWER
u, *
1 ‘“”=
To play equipment connected to VIDEO/AUX IN jacks or MD
jacks, proceed as follows.
1
2
Press VIDEO/AUX or MD.
When an equipment connected to VIDEO/AUX IN jacks is
played:
press VIDEO/AUX.
When an equipment connected to MD jacks is played:
press MD.
Play the connected equipment.
To change a source name in the display
When VIDEO/AUX is pressed, VIDEO is displayed initially. It can
be changed to AUX or TV.
With the power on, press POWER while pressing VIDEO/AUX.
Repeat the procedure to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as follows.
1 Press VIDEO/AUX or MD and play the equipment.
2 Press ++ or -so that the sound level becomes the same
as that of other function sources.
m
During recording, the sound level can not be adjusted.
When the CD DIGITAL OUT (OPTICAL) jack is not being used
Attach the supplied dust cap.
23 ENGLISH