Filter
Top Products
This section explains how to record from the tuner, CD player, or
external equipment.
4
3
Preparation
● Set the tape to the point where recording will start.
● Use Type I (normal) and Type II (high/CrOz) tapes for recording.
1
2
3
4
5
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
A EJECT
I
4
Press REV MODE to select the reverse mode.
To record on one side only, select z.
To record on both sides, select Z) or C=).
Press DOLBY NR to turn Dolby NR on or off.
To record with DOLBY NR, turn on no NR,
To record without DOLBY NR, turn
off DO NR.
Press function (CD, TUNER, VIDEO/AUX or MD)
and prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source, press VIDEO/AUX or
MD and play.
Press
● RECIREC MUTE to start recording.
To stop recording, press
■ .
To pause recording, press II. (Applicable when the source is
TUNER, VIDEO/AUX or MD.) To resume recording, press again.
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD.)
1 Press ● REC/REC MUTE during recording or while in
recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press II to resume recording.
To insert a blank space of less than 4 seconds, press
●
REC/REC MUTE again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press
● REC/REC MUTE
again. Each time the button is pressed, a 4-second blankspace
is added.
-. ~
..+.. ... .. -,:= .- , :,.1- ‘a.w$.*&amT--- r, .- :- .- = .-=+?
SOUND ADJUSTMENT DURING
RECORDING
The output volume and tone (except BBE and Rhythm play
function) of the speakers or headphones may be freely varied
without affecting the level of the recording.
Recording with BBE
The desired source can be recorded with the BBE function to
enhance the clarity of high-frequency sound. When playing back
a tape recorded with BBE, it is recommended that BBE be set to
off.
To erase a recording
Make sure the micro~hone is not connected to this unit and the
Rhythm play function (page 6 ) is canceled.
1 Insert the ta~e to be erased into deck 2 and press TAPEI
2
3
4
DECK 1/2 to”display “TP 2.
Set the tape to the point where the erasure is to be started.
Set the reverse mode by pressing REV MODE.
Press
● REC/REC MUTE to start the erasure.
15 ENGLISH