Filter
Top Products
J ..–-–-–. . . . .... ..-.l..–
1
2
3
CLOCK
Press CLOCK/TIMER once, then press II SET
within 4 seconds.
The hour flashes.
When using the remote control
Press CLOCK, then press II SET within 4 seconds.
Press < DOWN or FF UP to designate the
hour, and press 11 SET.
The hour stops flashing and the minute starts flashing.
Press + DOWN or * UP to designate the
minute and press II SET.
The minute stops flashing on the display and the clock starts
from 00 second. -
To display the current time
Press CLOCIQTIMER once. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press CLOCWTIMER once, then press ■ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
*MULTI JOG is also available instead of U and W.
ENTER is also available instead of II SET.
The unit can be turned off automatically at a specified time.
Use the remote control.
7
Press SLEEP.
2 Within 4 seconds, press - or ~ to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that “SLEEP oFF appears on the display.
‘MULTI JOG k also available instead of U and W.
21 ENGL/S/+