Filter
Top Products
67
GB
Additional Information
S-AIR function
S-AIR connection is not established
(sound transmission is not
established), e.g., the indicator of the
S-AIR sub unit turns off, flashes, or
turns red.
• If you use another S-AIR main unit, place
it more than 8 m away from this S-AIR
main unit.
• Confirm the S-AIR IDs of the S-AIR main
unit and S-AIR sub unit (page 54).
• Another S-AIR sub unit is paired to the
S-AIR main unit. Pair the desired S-AIR
sub unit with the S-AIR main unit (page
54).
• The S-AIR main unit is paired to another
S-AIR sub unit. Cancel pairing.
• Place the S-AIR main unit and S-AIR sub
unit separately from other wireless
devices.
• Avoid using any other wireless devices.
• The S-AIR sub unit is turned off. Make
sure the AC power cord (mains lead) is
connected and turn on the S-AIR sub unit.
No sound is heard from the S-AIR
product.
• If you use another S-AIR main unit, place
it more than 8 m away from this S-AIR
main unit.
• Confirm the S-AIR IDs of the S-AIR main
unit and S-AIR sub unit (page 54).
• Confirm the pairing setting (page 54).
• Place the S-AIR main unit and S-AIR sub
unit closer to each other.
• Avoid use of equipment that generates
electromagnetic energy, such as a
microwave oven.
• Place the S-AIR main unit and S-AIR sub
unit separately from other wireless
devices.
• Avoid using any other wireless devices.
• Change the “RF CHNG” setting (page 57).
• Change the S-AIR ID settings of the
S-AIR main unit and S-AIR sub unit.
• Turn off the receiver and S-AIR sub unit,
then turn on again.
There is noise or the sound skips.
• If you use another S-AIR main unit, place
it more than 8 m away from this S-AIR
main unit.
• Place the S-AIR main unit and S-AIR sub
unit closer to each other.
• Avoid use of equipment that generates
electromagnetic energy, such as a
microwave oven.
• Place the S-AIR main unit and S-AIR sub
unit separately from other wireless
devices.
• Avoid using any other wireless devices.
• Change the “RF CHNG” setting (page 57).
• Change the S-AIR ID settings of the
S-AIR main unit and S-AIR sub unit.
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
AM
ANTENNA
Receiver
To ground
Ground wire
(not supplied)
Outdoor FM antenna
continued