Filter
Top Products
22
GB
6: Preparing the receiver
and the remote
Connect the AC power cord (mains lead) to a
wall outlet.
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1 Press ?/1 to turn on the
receiver.
2 Hold down ?/1 for 5 seconds.
“CLEARED” appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Insert two R6 (size-AA) batteries in the
RM-AAU058 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 60).
• When the remote no longer operates the receiver,
replace all the batteries with new ones.
Connecting the AC power cord
(mains lead)
Performing initial setup
operations
FRONT R
SPEAKERS
FRONT L SUR R SUR L CENTER
AC power cord (mains lead)
To the wall outlet
ACTIVE STANDBY
INPUT SELECTOR
MASTER VOLUME
?/1
1,2
Inserting batteries into the
remote