Filter
Top Products
34
GB
a)
For details, refer to the page in the parentheses.
b)
“CONTROL FOR HDMI” scroll across the display, then “CONTROL” appears.
c)
This parameter is only available when the result of the Auto Calibration is saved.
d)
When the Auto Calibration result is saved, you can adjust the setting in 0.01 meter increment.
e)
This parameter is only available when SAT input is selected.
f)
This parameter is only available if the S-AIR transmitter (not supplied) is inserted to the EZW-T100 slot on
the receiver.
g)
This parameter is only available when using the EZW-T100A wireless transceiver (for model of area code
CEL, CEK only).
Menu
[Display]
Parameters
[Display]
Settings Initial setting
S-AIR settings
[S-AIR]
(page 52)
S-AIR ID
f)
[S-AIR ID]
ID A, ID B, ID C ID A
PAIRING
f)
[PAIRING]
START, CONDIN START
S-AIR mode
f)
[MODE]
PARTY, SEPARATE PARTY
RF Change
f)
[RF CHNG]
RF AUTO, RF ON, RF OFF RF AUTO
RF Power
f)g)
[RF POWER]
PWR HIGH, PWR LOW PWR HIGH
S-AIR standby
f)
[STBY]
STBY ON, STBY OFF STBY OFF