Filter
Top Products
16
GB
You can use the supplied remote to operate the
receiver and to control the Sony audio/video
components that the remote is assigned to
operate.
Main remote commander
(RM-AAL021)
Remote commander
Name Function
A AV ?/1 (on/
standby)
Press to turn on or off the audio/
video components that the
remote is assigned to operate
(page 125).
If you press ?/1 (2) button at
the same time, it will turn off
the receiver and other Sony
components (SYSTEM
STANDBY).
Note
The function of the AV ?/1
switch changes automatically
each time you press the input
button (5).
B ?/1 (on/
standby)
Press to turn the receiver on or
off.
If zone 2 or zone 3 is selected,
only the main receiver is turned
on or off with this button. To
turn off all components
including an amplifier in zone 2
or zone 3, press ?/1 and AV ?/
1 (1) at the same time
(SYSTEM STANDBY).
Saving the power in
standby mode.
When “Control for HDMI”
(page 114) and “RS-232C
Control” (page 116) are set to
“OFF.”
C ZONE Press to switch the zone 2 or
zone 3 operation (page 78).
D AMP Press to enable the receiver
operation (page 44).
E Input
buttons
Press one of the buttons to
select the component you want
to use. When you press any of
the input buttons, the receiver
turns on. The buttons are
factory assigned to control Sony
components (page 57). You can
program the remote to control
non-Sony components
following the steps in
“Programming the remote”
(page 125).
F TV INPUT Press TV (wf), then press TV
INPUT to select the input signal
of a TV.
G WIDE Press TV (wf), then press
WIDE repeatedly to select the
wide picture mode.