Filter
Top Products
11
RGB GRAPHICS
This input should be connected to an RGB-type video or graphic
signal using a cable with a DB15HD type connector.
The signal source device (typically a personal computer or game
console) must be able to provide separate H/V synchronisation
or composite H+V.
The video or graphic signals that can be connected to this
input can have horizontal scan frequencies (H-sync) of between
32 and 80 kHz and a vertical frequency (V-sync) of between 48
and 100 Hz. Image resolution can vary between 640x480 and
1600x1200 pixels (VGA, SVGA, XGA, SXGA, UXGA).
DVI-D
This input allows you to advantage from the quality of the digital
images .
If your source is equipped with a DVI-D output, YCrCb or RGB
connect it to this input to exploit the quality of the HT300 LINK
system.
HDMI™
12
With this input it is possible to integrate the optimal quality of a
digital image with a multichannel audio signal.
The HDMI™ (High Definition Multimedia Interface) in fact inte-
grates a multichannel audio signal with the uncompressed high
definition video signal.
The interface also allows the exchange between the video
source and the HT 300 LINK system of control data to optimise
the quality of the projected image.
The HDMI™ input allows connection to video sources that use
the HDCP (High-Bandwidth Digital Content Protection) proto-
col to protect their contents. This protocol is in fact incorpo-
rated in the definition of the HDMI™ technology.
Once the video source has been connected to the HDMI™
input, internal processing by the DIGIOPTIC IMAGE PROC-
ESSOR separates the video information from the audio infor-
mation. This information is then made available via an optical
digital output with a female TOSLINK connector in accordance
with the S/PDIF standard.
CONTROL (RS232)
The system can be controlled via a personal computer or home
automation systems by means of the serial port: simply connect
this input via a serial cable from an RS232 serial port. On
request, SIM2 will send you a document containing the serial
port settings and the list of main commands.