Filter
Top Products
E-15
SD-AT1000W_LAG_E2.fm04/7/21
SD-AT1000W
ENGLISH
TINSZA121AWZZ
Preparation for Use
- System installation -
System installation
" Placing the speaker system
The best surround effect will be achieved by placing each speaker at the same
distance from the listening position.
It is recommended to arrange the speakers as shown below.
Notes:
! Place the TV halfway between the front speakers.
! It is recommended that the centre speaker be placed near the television.
! Place the surround speakers at a position just above the height of your ears.
! The subwoofer vibrates whilst reproducing bass. Place it on a stable, sturdy sur-
face.
! The subwoofer reproduces bass. Place it anywhere you like.
" Magnetically shielded speakers
The front, centre and subwoofer speakers may be placed beside or near the TV as
they are magnetically shielded. However, discolouration may occur depending on the
TV type.
If colour variation occurs...
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present...
Move the speakers further away from the TV.
Refer to the user's manual of the TV for details.
Note:
The surround speakers are not magnetically shielded.
Note:
The default distance is set to 2 m. If speakers cannot be placed at equal distances,
refer to "Speaker delay setting" (see page 25).
Installation image:
The speaker stands are optionally available (see page 31). Refer to their instructions
for assembly.
Front
speaker (left)
Subwoofer
Front
speaker (right)
Surround
speaker (left)
Surround
speaker (right)
Default setting:
2 m
Centre
speaker
Front speaker (left)
Same distance
Front speaker (right)
Centre speaker
Same distance