Filter
Top Products
E-14
SD-AT1000W_LAG_E2.fm04/7/21
SD-AT1000W
ENGLISH
TINSZA121AWZZ
2
3
4
5
6
7
8
1
Preparation for Use
- Setting the AM/FM interval -
Setting the AM/FM interval
The International Telecommunication Union (ITU) has established that member coun-
tries should maintain either a 10 kHz or 9 kHz interval between broadcasting frequen-
cies of AM stations and 100 kHz or 50 kHz for FM stations. The illustration shows the
50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
This product is not equipped with a span selector. However, it will be adjusted to a 10
kHz AM (100 kHz FM) interval when shipped from the factory.
Before using the unit, be sure to set it to the AM/FM tuning interval (span) used in
your area.
To change the AM/FM tuning interval:
Note:
The AM/FM tuning interval will not change unless you press the ENTER button within
6 seconds.
Caution:
! When the unit is left for a few hours after the span has been switched and the AC
power lead disconnected, the AM span will be automatically returned to 10 kHz
(FM span to 100 kHz). If this happens, set the span again.
! When the span is switched, all the memorised stations will be cancelled.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst holding down the TUNER (BAND) button, press the ON/STAND-BY button.
3 Within 6 seconds, press the TUNING ( or ) button to select the interval (span)
in your area.
The display switches each time you press the button.
4 Within 6 seconds, press the ENTER button on the remote control.
! The unit will enter the power stand-by mode automatically.