Filter
Top Products
66
Troubleshooting
Symptom Check Remedy
Can't select Dolby Pro
Logic llx mode.
• Is the input signal selected properly? • Only 2 channel signal can select
Dolby Pro Logic IIx mode. (ex:Dolby
Digital, PCM, 2 channel analog input
signal.)
Can't select NEO:6 mode.
• Is the input signal selected properly? • Use PCM and Analog input signal.
There is no sound when
playing a DTS encoded
DVD.
• Is Digital input selected? • Check whether the DVD player is
properly connected and refer to
page 36 to select the digital input.
Product protection function
Heat protection
The protection function will come on if the main unit or power transformer overheats.
" " will appear in the display .
This function will come on :
- If speaker terminal is shorted
- If speaker cable is shorted
If there is no problem when you turn the unit on again after turning it off, PROTECTION mark will disappear on the
display and the unit will work properly.
If PROTECTION appears on the display, check whether the speaker terminal is shorted and then turn on
the unit again.
ASC Error List
Error No. VFD Message Action
E01
HP CONCT
Disconnect the headphones.
E02
NO MIC
Connect the microphone.
E03
NOISY
Take an appropriate action to reduce the surrounding noise.
E04
MIC LEVL
The speaker is too close to the microphone.
Check the distance between speaker and microphone.
E05
NO FRONT
Check if the front speaker is connected properly.
E07
LEVL OVR
Check the position of each of speaker and microphone.
E08
DIST OVR
The distance between speaker and microphone exceeds the acceptable value.
Check the location of microphone and each speaker.
E13
TIME OVR
Unplug the power cable and plug it back.
Then, perform ASC again.
E14
CODE ERR
Unplug the power cable and plug it back.
Then, perform ASC again.
•
M
- HW-C900-XAA_0831.indd 66 - HW-C900-XAA_0831.indd 66 2010-08-31 6:22:332010-08-31 6:22:33