Filter
Top Products
Specifications
78 RS-900 and RS1100 Series Installation/Operation Manual
P
RELI
M
INARY
Brightness and Contrast: Cinema Standards Measurement System (CSMS)
Specifications – RS-900 Series
- Brightness*: 13.9 to 19.8 foot-Lamberts (fL)
- Contrast Ratio*: 200:1 to 220:1
Cinema Standards Measurement System (CSMS)
Specifications – RS1100 Series
- Brightness*: 14.9 to 21.8 foot-Lamberts (fL)
- Contrast Ratio*: 205:1 to 225:1
*Variable depending on RVR setting
These measurements are taken from the projector in a controlled,
home theater environment. All measurements are made to
ANSI/NAPM IT7.228-1997 specifications using the Photo Research
PR-650 SpectraColorimeter and Minolta LS-100 Luminance Meter,
Video Essentials test DVD and a 1.3 gain, 72-inch wide screen. The
projector is calibrated to a color temperature of 6,500K and has a
minimum of 150 hours of usage.
The foot-Lambert (fL) is the unit of measurement used in commercial
movie theaters to express image brightness at the screen surface. The
Society of Motion Picture and Television Engineers (SMPTE) specifies
16 fL as the target image brightness for film-based projectors using an
open gate (without film in the projector). More importantly, today
SMPTE specifies 12 fL as the target image brightness in Digital
Cinema theaters. The foot-Lambert measurement is dependent on
screen size, screen gain and projector light output.
Home Theater Calibration Specifications –
RS-900 Series
- Light Output: 438 to 543 ANSI Lumens
- Contrast Ratio*: 200:1 to 220:1
Home Theater Calibration Specifications –
RS1100 Series
- Light Output: 447 to 591 ANSI Lumens
- Contrast Ratio*: 205:1 to 225:1
These specifications are obtained by calibrating the projector as
described above for CSMS measurements.
Industry-Standard Specifications – RS-900 Series
- Light Output: 1200 ANSI Lumens
- Contrast Ratio: 3000:1
Industry-Standard Specifications – RS1100 Series
- Light Output: 1300 ANSI Lumens
- Contrast Ratio – RS1100 Ultra: 1600:1 to 3200:1
- Contrast Ratio – RS1100: 11,000:1
These are typical projector brightness and contrast specifications
found in most companies’ sales literature. Runco includes these
measurements in its literature to allow for direct comparison with other
manufacturers’ projectors. These measurements are typically taken at
9,000K to 13,000K to get expected performance data when the
projector is used in professional, commercial and industrial displays.
Lamp: 200 Watts
Estimated Lamp Life: 2000 hours
Video Inputs: (1) Composite Video, (1) S-Video, (1) RGB/Component Video
(5
x BNC), (1) RCA Component Video (3 x RCA), (2) HDMI
Control Options: - Discrete IR remote
- Serial commands via RS-232
RS-232 Communication
Parameters:
19200 bps, no parity, 8 data bits, 1 stop bit, no flow control
Table 7-1. RS-900/RS1100 Specifications (continued)