Filter
Top Products
Installation
14 RS-900 and RS1100 Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the RS-900/RS1100 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 15
2
If installing a CineWide-equipped projector: Install
AutoScope lens motor or fixed CineWide base plate
(optional)
21
3
Mount the projector 30
4
Connect signal sources to the RS-900/RS1100 31
5
Connect external controller to RS-232 port (optional) 35
6
Connect 12-volt trigger output to AutoScope lens motor or
other equipment (optional)
36
7
Apply power to the projector 37
8
Primary lens adjustments: focus, projected image size
(zoom) and position (shift)
18, 38
9
Change the OSD Language (optional) 38
10
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
39
11
Install CineWide anamorphic lens (optional) 39
12
CineWide lens adjustments: position, pitch (angle),
geometry and focus
42
13
Projector calibration: adjust the following for each input;
save settings when finished:
Aspect ratio
Brightness
Contrast
Color level
Tint
Input position
57 through 62
Note