Filter
Top Products
Installation
RS-900 and RS1100 Series Installation/Operation Manual 25
PRE
L
IMINAR
Y
Install Lens Motor:
1. Position the AutoScope Lens Motor (item #2) as shown in Figure 3-9.
2. Line up the mounting holes on the lens motor housing with those on the underside of
the projector.
3. Secure the motor to the projector with the four (4), supplied 10-32 Pan-Head Phillips
screws (item
#1) and nylon spacers or aluminum standoffs (item #7).
4. Secure the AutoScope Ceiling Mount Adapters/Projector Stands to the motor using
the two (2), supplied 10-32 Flat-Head Phillips screws (item #3).
Figure 3-9. AutoScope Lens Motor Installation
After you have installed the AutoScope lens motor, proceed with Mounting the
RS-900/RS1100 on page 30.