Filter
Top Products
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
70
Information
Set up UPnP access on a Windows PC - cont.
4. Rotate the Tuning/Select control until 'Shared media' is highlighted
and press the control to select. The radio will scan for all available
UPnP servers. It may take a few seconds for the radio to complete its
scan. The radio will display '<Empty>' if no UPnP servers are found.
5. After scanning, select your UPnP server using the Tuning/Select
control. If you are using Windows Media Player 11 as the server, your
radio will then normally display 'Unauthorised' at this stage.
6. Your PC may prompt you that there has been a connection to your
UPnP server. Whether prompted or not, in order that the radio may
access the music fi les, you will need to click the 'Library' tab in WMP 11
and select the 'Media Sharing…' item to open the 'Media Sharing'
window. Make sure the box 'Share my media to:' is ticked.
7. In the 'Media Sharing' window, the radio will be listed as an unknown
device. Click on the unknown device shown to select it, then click the
'Allow' button and then click 'OK'.
Note: If you are using Microsoft Windows' fi rewall software, this should
be correctly confi gured by WMP 11. If you are using third party fi rewall
software you may need to manually confi gure it to allow your unit
and WMP 11 to communicate (see the 'Troubleshooting' section on
page 67).
8. On the radio, select the named server again using the Tuning/Select
control. If WMP 11 is now able to communicate with your radio you
will be presented with some media selection options on the display.
In the event that you are unable to make your radio work with WMP 11
then the reason is most likely related to security settings in your software
fi rewall or router. Please refer to 'Music Player / UPnP problems' on page 68.
Allowing a device to connect to Windows Media Player 11
7
4,5,8