Filter
Top Products
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
14
Confi guration
Connecting to your computer network - cont.
WEP keys are 10 or 26 characters long (using 0 - 9, and A - F). Some wireless
routers can also use pass-phrases for WEP but these are not supported. WPA
keys are usually set up using a pass-phrase of between 8 and 63 characters.
Your radio accepts pass-phrases for WPA keys.
16. To enter the WEP or WPA key, characters are selected and entered using the
Tuning/Select control. As you rotate the control, the highlight scrolls through
the available characters as well as the three controls on the right. The character
currently highlighted will be entered when you press the Tuning/Select control.
Do this as needed until the complete key has been entered. Remember, WEP
keys only use the numbers 0-9 and letters A-F. WPA keys are sensitive to upper
and lower case characters. You must enter the key exactly or the radio will not
connect to the network.
The three controls on the right-hand side of the screen have special functions.
You can quickly access these by pressing the Preset button and then use the
Tuning/Select control as needed. See also 'Text Entry' on page 9.
select '
' to erase a character just entered (long press to clear)
select '
' when the complete key has been entered
select '
' to cancel and re-run the Network Wizard
If a WEP or WPA key has previously been entered for the selected SSID then the
display will show 'Key: [Set]'. If you have previously entered a different key, you must
clear this by selecting the '
' symbol. This will remove the '[Set]' indication.
After the fi nal character of the WEP or WPA key has been entered, highlight
the '
' symbol and press the Tuning/Select control. The screen will show
'Connecting...' and then 'Setup wizard completed'. Press the Tuning/Select
control to the exit setup wizard. The radio should now be able to connect to
the network.
17. Once connected to the network your radio will display the main menu. Press
and release the On/Off button to put the radio into Standby mode. It should
then display the time as obtained from the Internet. If the time displayed is not
correct for any reason, it can easily be adjusted later, see page 51, 'Manually
setting the clock'. The clock display will switch off after 30 seconds if the radio
is running on batteries.
13-16
16
17