Filter
Top Products
49
Clock and Alarms
Automatically updating the clock
Your radio will normally update the clock automatically when connected to
the internet. If you enter a time setting manually, the radio will calculate a
local time offset which is then stored in memory. Whenever it synchronises
the clock using the internet, including after a power failure, your radio will
then set the clock automatically using this information.
Alternatively you may specify that the time is not automatically updated. In
this case the clock must always be set manually after a power interruption.
1. With your radio switched on, press and hold the Menu button to access
the menu for the current mode.
2. Rotate the Tuning/Select control until 'System settings' is highlighted
on the display. Press the control to enter the system settings menu.
3. Rotate the Tuning/Select control until 'Time/Date' is highlighted on
the display. Press the control to enter the time setup.
4. Rotate the Tuning/Select control until 'Auto update' is highlighted on
the display. Press the control to enter the auto-update menu.
5. Rotate the Tuning/Select control to choose an update option from
'Update from Network' or 'No update' as required. Press the control
to confi rm your choice. The radio will then exit to the previous menu
display.
1
2-5