Filter
Top Products
Adjusting initial settings
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function status.
1 Press and hold SOURCE to turn the
source off.
2 Press FUNCTION and hold until the
clock appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
ClockAUX (auxiliary input)Dim (dimmer)
CONT (display contrast)D.ATT (digital at-
tenuator)Mute (telephone muting/attenua-
tion)E.SCL (ever scroll)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down FUNCTION until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press FUNCTION repeatedly until clock ap-
pears in the display.
2 Push Multi Control left or right to select
the segment of the clock display you wish
to set.
Pushing Multi Control left or right will select
one segment of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Push Multi Control up or down to set
the clock.
Pushing Multi Control up will increase the se-
lected hour or minute. Pushing Multi Control
down will decrease the selected hour or min-
ute.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX ap-
pears in the display.
2 Push Multi Control up or down to turn
AUX on or off.
Pushing Multi Control up or down will turn
AUX on or off and that status will be displayed
(e.g., AUX :ON).
Initial Settings
En
46
Section
11