Filter
Top Products
Using the position selector
One way to assure a more natural sound is to
clearly position the stereo image, putting you
right in the center of the sound field. The posi-
tion selector function lets you automatically
adjust the speakers output levels and inserts
a delay time to match the number and posi-
tion of occupied seats.
1 Press DSP to select the position selec-
tor.
Press DSP until Posi appears in the display.
# If the position selector has been previously set
to a listening position then the title of that pre-
viously selected listening position will be dis-
played instead of Posi.
2 Push Multi Control left, right, up or
down to select a listening position.
Direction Display Indicator Position
Up Front
Front seats
Down All
All seats
Left Front-L
Front seat
left
Right Front-R
Front seat
right
# To cancel the selected listening position, push
Multi Control in the same direction again.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position to match the type of car. There are five
types of car stored which you can easily recall
at any time.
Here is a list of the types of car:
Display Type of car
SEDAN Sedan
Wagon Wagon
Mini-Van Mini van
SUV SUV
Custom Custom
1 Press DSP to select the time alignment
mode.
Press DSP until SEDAN appears in the display.
2 Push Multi Control left or right to select
the type of car.
Each pushing Multi Control left or right se-
lects types of car in the following order:
SEDANWagonMini-VanSUV
Custom
Note
Custom is an adjusted time alignment that you
can create for yourself.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in Custom.
1 Press DSP to select the time alignment
mode.
Press DSP until SEDAN appears in the display.
2 Push Multi Control up or down to select
a unit of distance.
Each pushing Multi Control up or down will
switch between cm (centimeter) and inch
(inch) and that status will be displayed.
3 Press DSP to adjust the time alignment.
Press DSP until F-L appears in the display.
Digital Signal Processor
En
44
Section
10