Filter
Top Products
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, use the HPF
(high pass filter) . Only frequencies higher
than those in the selected range are output
from the front or rear speakers. You can set up
front and rear separately.
Adjusting high pass filter
attenuation slope
1 Press AUDIO to select the slope setting.
Press AUDIO until Slope (front high pass filter
slope) or Slope (rear high pass filter slope) ap-
pears in the display.
2 Push Multi Control left or right to select
slope.
Each pushing Multi Control left or right se-
lects slopes in the following order:
0612 (dB/oct.)
# Push and hold Multi Control down to mute
the selected speaker unit, when you adjust the
other speaker unit.
You can cancel the muting by pushing
Multi Control up.
Adjusting high pass filter setting
1 Press AUDIO to select 80.
Press AUDIO until 80 (front high pass filter
cut-off frequency) or 80 (rear high pass filter
cut-off frequency) appears in the display.
2 Push Multi Control left or right to select
Slope.
Each pushing Multi Control left or right se-
lects cut-off frequencies in the following order:
506380100125160200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
3 Push Multi Control up or down to ad-
just the output level of the speakers.
Each pushing Multi Control up or down in-
creases or decreases the level of the front or
rear speakers. 0 24 is displayed as the level
is increased or decreased.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
! Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2 Press AUDIO and hold until SLA ap-
pears in the display.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
3 Push Multi Control up or down to ad-
just the source volume.
Each pushing Multi Control up or down in-
creases or decreases the source volume.
SLA : +4 SLA : 4 is displayed as the source
volume is increased or decreased.
Notes
! If you do not operate the SLA function within
about 30 seconds, the display is automatically
returned to the source display.
! The AM tuner volume level can also be ad-
justed with source level adjustments.
! The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
! External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
Audio Adjustments
En
41
English
Section
09