Filter
Top Products
7
Hooking Up the VCR
RCA Digital Satellite Receiver
B. Advanced hookup with
basic receiver.
Use this hookup if your TV has audio/video
jacks and your receiver has one set of
AUDIO/VIDEO jacks.
1. Set the CH3 CH4 switch on back of
receiver to either channel 3 or 4.
You will tune the VCR to this channel to
record from the satellite receiver. To watch
the satellite receiver, tune your TV to its
video input channel. If you want to watch
or record the signal from your antenna,
cable, or cable box, make sure the satellite
receiver is turned off.
2. Set the CH3 CH4 switch on back of VCR
to either channel 3 or 4.
You will tune the TV to this channel and
use the TV•VCR button to watch the VCR.
3. Connect as shown.
This connection may require additional
accessories not provided.
4. Plug in power cords of VCR, TV, and
receiver.
5.
C. Advanced hookup with
deluxe receiver.
Use this hookup if your TV has audio/video
jacks and your receiver has two sets of
AUDIO/VIDEO jacks.
1. Set the CH3 CH4 switch on back of VCR
to either channel 3 or 4.
You will tune the TV to this channel and
use the TV•VCR button to watch the VCR.
To record from the satellite receiver, you
will tune the VCR to its line input (L1). To
watch the satellite receiver, tune your TV
to its video input channel.
2. Connect as shown.
This connection may require additional
accessories not provided.
3. Plug in power cords of VCR, TV, and
receiver.
4.
Go to ÒStartupÓ section.
Go to ÒStartupÓ section.
VIDEO R AUDIO L