Filter
Top Products
6
Hooking Up the VCR
RCA Digital Satellite Receiver
VIDEO R AUDIO L
S-VIDEO
CH3
CH4
IN FROM ANT
SATELLITE IN
OUT TO TV
Back of VCR
Back of Satellite Receiver
From
Satellite
Dish
RF Coaxial Cable
Audio/Video Cables
(supplied)
From
Cable, Cable Box
or Antenna
OUT TO TV
IN FROM
ANT.
VHF/UHF
3 CH. 4
IN
OUT
VIDEO1AUDIO1
R L
Back of TV
Cable/
Antenna
OR
VHF
UHF
RF Coaxial Cable
(supplied)
75 to 75/300 Ohm
Separator
Position the satellite receiver.
Position the receiver on top of the VCR. You
may need to position it at different angles
before the VCR can control it. Make sure the
receiver does not cover the transmitting
window on top of the VCR.
A. Basic hookup.
Use this hookup if your TV does not have
audio/video jacks.
1. Set the CH3 CH4 switch on back of
satellite receiver to either channel 3 or 4.
You will tune the VCR to this channel or
its line input (L1) to record from the
satellite receiver. To watch the satellite
receiver, turn off the VCR. If you want to
watch or record the signal from your
antenna, cable, or cable box, make sure the
satellite receiver is turned off.
2. Set the CH3 CH4 switch on back of VCR
to either channel 3 or 4.
You will tune the TV to this channel and
use the TV•VCR button to watch the VCR.
3. Connect as shown.
This connection may require additional
accessories not provided.
4. Plug in power cords of VCR, TV, and
receiver.
5.
Go to ÒStartupÓ section.
A
Transmitters
Remote Sensor
Satellite Receiver
Caution: The unauthorized recording of satellite
broadcasts, television programs, or other
materials may infringe the rights of others.