Pioneer VSX-916-K Stereo Receiver User Manual


 
Additional information14
68
En
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the
STANDBY/ON button for
about three seconds.
3 When you see RESET? appear in the
display, press
ENTER
.
OK?
shows in the display.
4 Press
SETUP
to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory settings.
Switching the speaker
impedance
We recommend using speakers of 8
with this
system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
impedance rating.
With the receiver in standby, press
STANDBY/ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
SP 6 OHM
– Use this setting if your
speakers are rated at 6
.
SP 8 OHM
– Use this setting if your
speakers are rated at 8
or more.
Changing the TV format setting
If the System Setup menu is not displayed
correctly, it may be that the TV system is set
incorrectly for your country or region.
With the receiver in standby, press
STANDBY/ON while holding down the
SIGNAL SELECT button.
The display shows the new setting (
PAL
or
NTSC
).
The SR cable is connected, but
the connected components
can’t be operated with the
remote.
• Reinsert the SR cable, making sure it’s connected to the right jack (see
Using this
receiver with a Pioneer plasma display
on page 61).
• Make sure an analog connection has been made between the units.
• This feature only works with Pioneer products.
The display is dark or off. • Press
DIMMER
on the control repeatedly to return to the default.
The
System Setup
screen
doesn't appear.
• When the receiver is in standby, switch to
BURST.OFF
by holding down
ACOUSTIC
EQ
(front panel) and pressing
STANDBY/ON
(the current setting is displayed).
USB mass storage device is
not recognized by the receiver.
• Try switching the receiver off, then on again.
• Make sure you have completely inserted the USB connector to this receiver.
• Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and HFS are not
supported).
• USB devices with an internal USB hub are not supported.
USB ERR3
shows in the display
when connecting a USB
device.
• If this message continues to appear after going through all the checks in
Important
on page 34 of
USB playback
, take the unit to your nearest Pioneer
authorized service center or your dealer for servicing.
Can’t play audio files. • The WMA or MPEG-4 AAC files were recorded using DRM (digital rights
management), or the bit rate/sampling rate is not compatible (see
Compressed
audio compatibility
on page 35). This is not a malfunction.
Problem
Remedy
VSX_916.book.fm 68 ページ 2005年12月22日 木曜日 午後4時21分