Pioneer VSX-916-K Stereo Receiver User Manual


 
Controlling the rest of your system11
50
En
Chapter 11:
Controlling the rest of your
system
Operating other Pioneer
components
Many Pioneer components have SR
CONTROL
jacks which can be used to link components
together so that you can use just the remote
sensor of one component. When you use a
remote control, the control signal is passed
along the chain to the appropriate
component.
1
Note that if you use this feature,
make sure that
you also have at least one set of analog audio or
video jacks connected
to another component
for grounding purposes.
Setting the remote to control
other components
Most components can be assigned to one of
the
MULTI CONTROL
buttons using the
component’s manufacturer preset code stored
in the remote.
However, please note that there are cases
where only certain functions may be
controllable after assigning the proper preset
code, or the codes for the manufacturer in the
remote control will not work for the model that
you are using.
2
Note
You can cancel or exit any of the steps by
press and hold
RECEIVER
for two seconds.
To go back a step, press
RETURN
.
After one minute of inactivity, the remote
automatically exits the operation.
Note
1• If you want to control all your components using this receiver’s remote control, refer to
Controlling the rest of your system
on page 50.
• If you have connected a remote control to the
CONTROL IN
jack (using a mini-plug cable), you won't be able to control this
unit using the remote sensor.
CONTROL
OUT
IN
CONTROL
OUT
IN
Receiver
Remote
control
unit
Other Pioneer products
with CONTROL terminals
Connect to CONTROL
terminal of other
Pioneer products
2• TV codes (for example, codes for TV, CATV or Satellite TV) can only be assigned to the
TV/SAT
or
TV CTRL
button.
• If you assign the
AM
or
FM
function to another component, you will have to reassign it to the Pioneer preset code to use
this receiver’s built-in tuner.
VSX_916.book.fm 50 ページ 2005年12月22日 木曜日 午後4時21分