Filter
Top Products
Other connections
12
59
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 12:
Other connections
Caution
•
Before making or changing the connections
,
switch off the power and disconnect the
power cord from the power outlet.
Plugging in components should be the last
connection you make with your system.
• Do not allow any contact between speaker
wires from different terminals.
• You can use speakers with a nominal
impedance between 6
Ω
to 16
Ω
(please
see
Switching the speaker impedance
on
page 68 if you plan to use speakers with an
impedance of less than 8
Ω
).
Second Zone speaker B setup
After selecting
Second Zone
in
Surround back
speaker setting
on page 36, you can use the
speakers connected to the (surround back) B
speaker terminals on the rear panel to listen to
stereo playback in another room. See
Switching the speaker system
below for the
listening options with this setup.
1 Connect a pair of speakers to the
surround back speaker terminals on the rear
panel.
Connect them the same way you connected
your speakers in
Connecting the speakers
on
page 19. Make sure to review
Hints on speaker
placement
on page 20 when placing the
speakers in another room.
2 Select ‘
Second Zone’
from the ‘
Surr Back
System’
menu.
See
Surround back speaker setting
on page 36
to do this.
Switching the speaker system
If you selected
Second Zone
in
Surround back
speaker setting
on page 36, three speaker
system settings are possible using the
SPEAKERS
button. If you selected
Normal (SB)
or
Front Bi-Amp
, the speaker system is fixed
as
SP
A
or
SP
AB
(respectively). The options
below are for the
Second Zone
setting only.
1
• Use the SPEAKERS button on the front
panel to select a speaker system setting.
Press repeatedly to choose a speaker system
option:
•
SP
A
– Sound is output from the speakers
connected to the A speaker terminals
(multichannel playback is possible).
•
SP
B
– Sound is output from the two
speakers connected to speaker system B
(only stereo playback is possible).
Note
1• The subwoofer output depends on the settings you made in
Speaker Setting
on page 42. However, if
SP
B
is selected above,
no sound is heard from the subwoofer (the LFE channel is not downmixed).
• Depending on the
Surround back speaker setting
on page 36 output from the surround back pre-out terminals may change.
• All speaker systems (except
Second Zone
connections) are switched off when headphones are connected.
MIDNIGHT/
LOUDNESS
QUICK
SETUP
SETUP
RETURN
TUNING/
STATION
TONE
PTY
SEARCH
SPEAKERS
TUNER
EDIT
EON
MODE
MULTI JOG
VSX_916.book.fm 59 ページ ２００５年１２月２２日 木曜日 午後４時２１分